Sponsored Ads. Advertise With Us!
Register    Login    Forum    Search    FAQ

Board index » Big Squid RC Forums » RC Rock Crawling




Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: I’m design a new comp chassis, need help.
 Post Posted: Mon Sep 08, 2008 7:43 pm 
Offline

Joined: Mon Mar 03, 2008 5:29 pm
Posts: 34
Location: bolingbrook il
I’m design a new comp chassis, need help. Any tips or measurements will help. I’m running r2 trans with disconnect and wheely king axils. And also need to know what drive shaft ends fit best on the r2 out put shafts. Hears ware i'm go my inspurshoin for my new chassis.http://www.deanguitars.com/dean_winter_06/usa_rebel_razorback.htm I'm going to be using the head part for my base design.[/code]


Top 
 Profile  
 
 Post subject:
 Post Posted: Thu Sep 18, 2008 1:05 pm 
Offline

Joined: Wed Jan 02, 2008 3:33 pm
Posts: 100
GOOD LUCK!!!

Download Solid Edge 2d then once your done with your design send it off to a waterjet cutter for cutting (water jet precision is great ask fo Carl and Tell him Jeff sent you)

Make your upper and lower links in a verticle line from each other 1" apart works great. Shock mounts usually work best between 7 1/2" and 8 1/2" apart.

Make sure you have a flat bottom on the chassis, as small as you can make it and still fit the trans. Make sure your lower links line up with your skid so you can use them like sliders.

Punisher shafts


Top 
 Profile  
 
 Post subject:
 Post Posted: Thu Sep 18, 2008 4:04 pm 
Offline

Joined: Mon Mar 03, 2008 5:29 pm
Posts: 34
Location: bolingbrook il
thanks jet for you input


Top 
 Profile  
 
Display posts from previous:  Sort by  
 
Post new topic Reply to topic  [ 3 posts ] 

Board index » Big Squid RC Forums » RC Rock Crawling


Who is online

Users browsing this forum: No registered users and 2 guests

 
 

 
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
cron