BigSquidRC.com

i read on the chicago forum that you were having probs with the one way on you tiger drive. for what motor? and did you get a new one? if its for a maxx and you didnt get one let me know. i found that the one way out of a gs b01 motor works great!! ive run over a gallon and a half with no slipping. i have an extra if you want it.

_________________
Official Big Squid Bash Crew

Thanks, but I'm going to see how it goes. I removed it and found I had a ton of grease on the actual shaft. So I cleaned it off, and used a q-tip to remove some from the inside of the bearing. It still slips a little, but started much better today. It's going to get a ton of use at the Bash this weekend, so I'll see how it holds up. I tried to remove the bearing from the tiger drive, and couldn't! It seemed like it was one piece with the larger gear? Maybe I'm wrong. It's a tiger drive for a OS 18 engine (in my t-maxx)

I was bummed my local shop didn't have a pull start that would fit it that I could use as a 'backup' incase this one did die =\

Oh well. Thanks for the offer! I'll see how it goes this weekend.
Brian

_________________
Brian(at)BigSquidRC.com
http://www.BigSquidRC.com