BigSquidRC.com

hi im really mad!!!!!!! this stupid kysho inferno doesn't want to start i used factroy settings for firespink.but i think i know whats happening
i think that the feul is not getting to the engine.when i put sone feul down the card it only starts for a little then stops.when i look at the feul line no feul is comming.what should i do?????

Easiest thing to do, is take the fuel line from the carb. Plug the end of the pipe, and pull the starter a few times. If the fuel comes up through the line this way, there is a clog in the carb. If no fuel comes up, there is no air pressure getting to the carb. Check the line from the Exhaust to the fuel tank, there may be a small hole, or a clog in the fittings.

IF after the first test, ou find that the clog is in the carb, take a small piece of fuel tubing and zip tie it to the end of the straw on a WD-40 can. Hook this up to the carb, and spray a short burst into the carb. If you do this, make sure to remove the glo-plug, and pull the starter a couple times while holding the car upside down. This will clear the WD-40 from the engine so you don't Hydro-lock (Flood) it.

Let us know if this works.

lol i will try that